Wireless Network Question: Cisco RV120

I have a friend I am helping. He has a home network - Everything coming off the main router is 10.1.1.XXX
He added a Cisco RV120 because he needed Wireless. Everything coming off it is 192.168.1.xxx

NOW. I need to make it so that the Cisco is more of an Access Point than a Router.
I need to not have it give out ip address but to pass through the ip address from the main DHCP

I am unsure how to do it. The Cisco configuration seems a bit different
There does not seem to be an easy way to do it.
I thought I should be done in the LAN setting but disabling it there
seems nothing is getting an IP address at all

So the question is how to I get the Wireless connection but still be in the main IP Address
(He has wireless printers that will need to be used by all the computers whether they are
connected via wireless or ethernet)

Thanks in Advance

Rocket River

 

I thought as much.
I have been googling and trying to find it in the particular model.
Cisco seems so different than other routers





Where it has DHCP Mode the options are DHCP RELAY and NONE
When in RELAY mode - the other computers are not picking up an IP Address at all
I cannot set the IP for the 10.1.xxx.xxx mode

Rocket River

 

I set the Static IP (on the wan)


(these are screen shots from generic setup but this is how I set it up)
The issue is that the LAN



I cannot set it up to be in the same 10.1.xxx.xxx here as in the wan.
I am not sure if I need too.
I tried it in the three states of NONE, DHCP RELAY and DHCP SERVER
Tried with the DNS Proxy enabled and disabled.

My googling is telling me I might need the CISCO on both ends
Some configuring of the MAC Addresses

Rocket River

 

https://supportforums.cisco.com/discussion/11522451/rv120w-wireless-bridge

Rocket River